Chapter 3 Creating and Editing Screens 3-230 Revision May, 2010 COM Port tab in Configuration option Add/ Delete/ Modify Delete Delete the existed connecting controller (one application needs to connect at least one controller). Modify Modify the connecting controller or change the controller name. Controller Settings COM Port Set the COM port that communicates with HMI PLC Station Set PLC station number. If PLC does not set station number, it will use this default setting. The range is between 0 ~ 255. Password Passwords are necessary for some connecting controllers before communication. Comm. Delay Time Set delay time for waiting the startup of external controller (i.e. PLC).
The range is between 0 ~ 255 ms. Timeout Set communication time out time when communicating with the external controller. The range is between 10 ~ 65535ms. . Retry Count HMI will try to send a communication command to the external controller repeatedly if the external controller does not respond during communication. This option is used to set the number of retry count times. A communication error dialog box will not appear unless the number of retry count times is reached. The range is between 0 ~ 255 times. Optimize When Optimize box is checked, optimization function is enabled. If optimization function is enabled, all read addresses of all related elements will be optimized.
When Communication Interrupt times then ignore box is checked, HMI stops communicating with the PLCs after the communication interrupt time is reached. The purpose of this function is to avoid the communication error dialog box will always show on the HMI screen when the communication error occurs after HMI has retried. The range is between 1 ~ 255 times. If the user wants to recover the communication between HMI and PLCs again when HMI stop communicating with the PLCs after the communication interrupt times are reached, the user can use Bit 0 of the control block D1 (suppose that the stating address is D0) to control HMI communication.
When Bit 1 is set to ON, it will disable HMI communication. When Bit 1 is set to OFF, it will enable HMI communication. Comm. Parameter HMI Station Set HMI station number. The range is between 0 ~ 255. Interface Set communication interface. There are three options RS232, RS422 and RS485. Data Bits There are two options 7 Bits and 8 Bits. Stop Bits There are two options 1 Bits and 2 Bits.