To Trigger the Oscilloscope EN 1. Type: Click on the Type menu label and select "RS232 trigger" to set RS232 trigger. After selecting the trigger type, the current trigger setting information (including trigger type, trigger signal source, and trigger level) will be displayed at the top of the screen, which changes with the trigger setting. 2. Source: Click on the Source menu tab and select CH1-CH4 or EXT. Only by selecting the channel that has been connected to the signal as the trigger source can stable triggering be obtained. 3. When: Select the desired trigger condition in the When menu tab. ⚫ Start: Triggered at the start position of the frame. ⚫ Stop:
Triggered at the end of the frame position. ⚫ Data: Triggered when the data reception is completed and the received data matches the data set by the user. ⚫ Check Error: Triggered when the data reception is completed and the verification result does not match the data set by the user. ⚫ Error: Triggered when an error frame is detected. 4. Polarity: Click on the Polarity menu tab to select the polarity for data transmission, which can be either positive or negative. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 82