Hantek — DPO7000 UserManual

To Trigger the Oscilloscope EN 1. Type: Click on the Type menu label and select "CAN trigger" to set the CAN trigger. After selecting the trigger type, the current trigger setting information (including trigger type, trigger signal source, and trigger level) will be displayed at the top of the screen, which changes with the trigger setting. 2. Source: Click on the Source menu tab and select CH1-CH4 or EXT as the specified source. Only by selecting the channel that has been connected to the signal as the trigger source can stable triggering be obtained. 3. When: Click the When menu button to select the desired trigger condition. ⚫ Start Bit: Triggered at the beginning of a data frame.

⚫ Remote Frame ID: Triggered on the remote frame with the specified ID. ⚫ Data Frame ID: Triggered on the data frame with the specified ID. ⚫ Frame ID: Triggered on the frame with the specified ID. ⚫ Frame ID and Data: Triggered on the data frame of the specified ID and the data frame of the specified data. After selecting the frame ID and data, click on the definition menu tab and select either data or ID. ⚫ Error Frame: Triggered on the error frame. ⚫ All Error: Triggered on all errors. ⚫ Ack Error: Triggered on confirmation error. ⚫ Overload Frame: Triggered on an overload frame. 4. Baud: Click on the Baud menu tab and select the preset rate from the pop-up menu. 5. ID:

Click on the ID menu tab and set the ID value by rotating the multi-functional knob V0 or the pop-up numeric keyboard. 6. Data: Click on the Data menu tab and set Data 1, Data 2, Data 3, and Data 4 by rotating the multifunctional knob V0 or the pop-up numeric keypad. 8.6.15 SPI Trigger (Option) Under the SPI trigger type, when the chip selection or timeout conditions are met, the oscilloscope triggers when it searches for the specified data. SPI trigger is a high-speed, DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 86