Hantek — DPO7000 UserManual

To Trigger the Oscilloscope EN 1. Type: Click on the Type menu label and select "I2C trigger" to set the I2C trigger. After selecting the trigger type, the current trigger setting information (including trigger type, trigger source, and trigger level) will be displayed at the top of the screen, which changes with the trigger setting. 2. Clock source: Click on the SLK menu tab and select CH1-CH4 or EXT as the specified clock source. Only by selecting the channel that has been connected to the signal as the trigger source can stable triggering be obtained. 3. Data source: Click on the SDA menu tab and select CH1-CH4 or EXT as the specified data source.

Only by selecting the channel that has been connected to the signal as the trigger source can stable triggering be obtained. 4. When: Click on the When menu tab to select the desired trigger condition. ⚫ Start: IIC start condition trigger detected. (Triggered when SCL is high and SDA data jumps from high level to low level.) ⚫ Stop: IIC stop condition triggered detected. (Triggered when SCL is high and SDA data jumps from low to high.) ⚫ Restart: Triggered when a new start condition appears before the stop condition. ⚫ MissedAck: Triggered if SDA data is high during any SCL clock bit. Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 89