Measure EN Figure 10.1 All Measure 10.4 Quick Measurement after AUTO After connecting the oscilloscope correctly, input a valid signal, press the [Auto Scale] button to automatically set the waveform and open the following function menu: ⚫ Single cycle: Set the screen to automatically display signals for a single cycle. Simultaneously measure the "time parameter" and "voltage parameter" of the current data source in a single cycle, and the measurement results are displayed at the bottom of the screen. ⚫ Multi cycle: Set the screen to automatically display signals for multiple cycles.
Simultaneously perform multi cycle "time parameter" and "voltage parameter" measurements on the current data source, and the measurement results are displayed at the bottom of the screen. ⚫ Automatic range: Select the scale automatically set by the system: "Horizontal vertical gear", "Horizontal gear", or "Vertical gear". ⚫ Data source: Set the channels to be automatically set: "Display only", "All". Display only: After the system performs automatic settings, only the waveform of the opened channel with signal input is displayed; All: After the system performs automatic settings, the waveforms of all channels with signal inputs are displayed.
10.5 Cursor Measurement The cursor can be used to measure the X-axis value (such as time) and Y-axis value (such as voltage) of the selected waveform. Before using the cursor for measurement, we need a stable waveform display. The cursor measurement function provides the following two types of cursors. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 116