Hantek — DPO7000 UserManual

To Set the Vertical System EN attenuated. Click to open [CH1] , and then click on the BW Limit menu to select the restricted bandwidth. You can choose to close, 20M, 100M, 200M, 350M, and the default is 20M. After opening the bandwidth limit, the color B at the channel label matches the channel color. Tip: Bandwidth limitation not only reduces noise, but also attenuates or eliminates high-frequency components in the signal. 5.6 Probe Ratio Open [CH1] , then click on the Attenuation to set the probe. The oscilloscope allows users to manually set the probe attenuation ratio, and users must set the probe ratio correctly to obtain accurate measurement results.

The default probe ratio is 1X, and the probe range is 0.01X-50000X. To match the actual attenuation ratio of the probe, it is necessary to adjust the channel attenuation ratio accordingly under the channel menu. Whenever the attenuation ratio of the probe changes, it is necessary to set the corresponding attenuation ratio in the channel menu to ensure the correctness of the waveform amplitude and measurement results displayed on the oscilloscope. Table 5.1 Probe Ratio DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 36 Menu Attenuation Ratio(display amplitude of the signal:

actual amplitude of the signal) 0.01X 0.01:1 0.02X 0.02:1 0.05X 0.05:1 0.1X 0.1:1 0.2X 0.2:1 0.5X 0.5:1 1X 1:1 2X 2:1