To Trigger the Oscilloscope EN 8.1 Trigger LEVEL The trigger level is the signal voltage corresponding to the set trigger point, which is related to the type of trigger signal source. ⚫ The trigger flag and trigger level line move up and down as the trigger level changes. The trigger flag and channel color remain consistent. When changing the trigger level, a trigger level line will temporarily appear on the screen to tell you the position of the level (the specific value of the trigger level is displayed in the trigger menu label at the top right of the screen). After about 2 seconds of stopping modifying the trigger level, the trigger level line disappears.
⚫ For slope triggering, under amplitude triggering, and over amplitude triggering, it is necessary to set the triggering levels: the level values of level A and level B. Through the Level Select menu in the [Trig Menu] menu, select the current adjustable levels as level A, level B, and level AB. The trigger level can also be adjusted through the touch function. ⚫ Using the touch screen function, touch the trigger setting label in the upper right corner of the screen to pop up the trigger setting box as shown in the following figure. Touch the right side of the level value input box to increase or decrease the level value.
You can also touch the value input box and directly input the specific value through the pop-up numeric keyboard. 8.2 Trigger Sensitivity The trigger sensitivity indicator shows the sensitivity of the trigger signal recognition. By adjusting the trigger sensitivity, it can effectively filter out the noise that may be superimposed on the trigger signal and prevent false triggering. Click on the trigger label in the upper right corner of the screen to pop up the trigger setting box and set the sensitivity. Set trigger Sens : DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 58