To Trigger the Oscilloscope EN 3. Slope Type: Click on the Slope Type menu label, and the edge types that can be selected include: rising edge, falling edge, or any edge. ⚫ Rising: Set the signal's rising edge to trigger. ⚫ Falling: Set the signal falling edge trigger. ⚫ Either: Set the signal to trigger the rising or falling edge. 4. Holdoff: Click on the Holdoff menu tab, and set the trigger suppression by selecting the multi-functional knob V0 or directly setting the trigger suppression with the pop-up numeric keyboard. 5. Noise Reject: Please refer to the introduction in the section on Noise Rejection for specific settings related to Noise Reject. Note:
The automatic setting button will set the trigger type to Edge trigger and the trigger slope to rising edge. 8.6.2 Pulse Trigger Pulse width trigger sets the oscilloscope to trigger on a specified width of positive or negative pulses. You can set the trigger source, polarity (positive pulse width, negative pulse width), limiting conditions, and pulse width in this menu. Figure 8.4 Positive Pulse Width/Negative Pulse Width Click on [Trig Menu] in the button area to open the trigger menu. Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 63