To Trigger the Oscilloscope EN 1. Type: Click on the Type menu label and select "Pulse" to set the trigger.After selecting the trigger type, the current trigger setting information (including trigger type, trigger source, and trigger level) will be displayed at the top of the screen, which changes with the trigger setting. 2. Source: Click on the Source menu tab to select sources such as CH1, CH2, CH3, CH4, and EXT. 3. Polarity: Click on the Polarity menu tab to select either positive or negative polarity. ⚫ Positive polarity: triggered when the positive polarity pulse width of the signal is set. ⚫ Negative polarity: triggered when the signal negative polarity pulse width is set. 4. When:
Click on the When menu tab and select Trigger Condition. ⚫ =(Equal to time value): Only when the positive or negative pulse width of the input signal is equal to the set pulse width can it be triggered. For example, for a positive pulse, if t (actual pulse width) is set to 200ns, the waveform is triggered. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 64