Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set  When Mark function is enabled, ramp down time is independent of the ramp up time. Users can set ramp up time in S 3 and ramp down time in D1348/D1349. (Range: 20ms~32767ms)  When Mark function is executed and the ramp-down stop pulses (DD1232/DD1234) are specified, PLC will execute ramp-down stop with specified pulses after Mark is detected. However, if DD1232/DD1234 are less than the specified ramp-down time (D1348 / D1349), PLC will fill DD1232/DD1234 with the value of ramp-down time. In addition, if DD1232/DD1234 is more than the half of total output pulses, PLC will modify DD1232/DD1234 to be less than half of the total output pulses.

 Ramp-down stop pulses (DD1232/DD1234) are 32-bit value. Set value K0 will disable the Mark function.  Y0,Y2 relative parameters for Mask and Alignment Mark function: Program example 1: M0 Y0 M0 FEND M1000 I401 IRET END Explanations:  When M0 is triggered, Y0 executes pulse output. If external interrupt is detected on X4, pulse output will perform ramp down process for 10,000 pulses and then stop. M1108 will be ON to indicate the pause status (ramp down). If no interrupt is detected, Y0 pulse output will stop after 1,000,000 pulses are completed.  When pulse output ramps down and stops after Mark is detected, M1538 will be ON to indicate the pause status.

If users need to complete the remaining pulses, set OFF the flag M1108 and pulse output will resume. 4. Operation of Mask function on Y0: 3-151 Parameter Pulse number Output Ramp Pulse number Input for ramp-down pause Pause Mark flag down for masking Output points of Mark (ramp status time output function down) Y0 M1156 X4 D1348 D1026, D1027 D1232, D1233 M1108 M1538 Y2 M1158 X6 D1349 D1135, D1136 D1234, D1235 M1110 M1540 SET M1156 DMOV K10000 D1232 DPLSR K100000 K1000000 K20 INCP D0