Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set 2. Steps: a) Set the four coordinates (-27000, -27000), (0, -55000), (27000, -27000) and (0,0) (as the figure above). Place them in the 32-bit registers (D200, D202), (D204, D206), (D208, D210), b) Design instructions as follows. (D212, D214). c) RUN the PLC. Set ON M0 to start the 2-axis line drawing. 3. Operation: When PLC runs and M0 = ON, PLC will start the first point-to-point motion by 100KHz. D0 will plus 1 whenever a point-to-point motion is completed and the second point-to-point motion will start to execute automatically. The operation pattern repeats until the fourth point-to-point motion is completed.

3-461 = D0 K1 DPPMA D200 D202 K100000 Y0 = D0 K2 DPPMA D204 D206 K100000 Y0 = D0 K3 DPPMA D208 D210 K100000 Y0 = D0 K4 DPPMA D212 D214 K100000 Y0 M0 RST M1029 ZRST D1336 D1339 MOV K1 D0 M0 M1029 INCP D0 END DPPMA D200 D202 K100000 Y0 END DPPMA D204 D206 K100000 Y0 DPPMA D208 D210 K100000 Y0 DPPMA D212 D214 K100000 Y0 RST M1029 ZRST D1336 D1339 MOV K1 D0 INCP D0