DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming API 224~ 230 Operands: S 1 : Source device 1 S 2 : Source device 2 Explanations: 1. This instruction compares the content in S 1 and S 2 . Take API224 (LD=) for example, if the result instruction is disabled. is “=”, the continuity of the instruction is enabled. If the result is “≠”, the continuity of the 2. LD ※ ( ※ : =, >, , ≤, ≥) instruction is used for direct connection with left hand bus bar. 3. When the MSB (16-bit instruction: b15, 32-bit instruction: b31) of S 1 and S 2 is 1, the comparison value will be viewed as a negative value in comparison. 4.
When 32-bit counters (C200 ~ C254) are used in this instruction, make sure to adopt 32-bit instruction (DLD ※ ). If 16-bit instruction (LD ※ ) is adopted, a “program error” will occur and the ERROR indicator on the MPU panel will flash. Program Example: 1. When the content in C10 = K200, Y20 = ON. 2. When the content in D200 > K-30 and X1 = ON, Y21 = ON and latched. Y20 X1 3-502 Mnemonic Operands Function Controllers D LD※ Contact Type Comparison ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F LD※: 5 steps DLD※:
9 steps S 1 * * * * * * * * * * * S 2 * * * * * * * * * * * PULSE 16-bit 32-bit ES2/ EX2 SS SA2/ 2 SE SX2 ES2/ SA2/ ES2/ SA2/ SS2 SX2 SS2 SX2 EX2 SE EX2 SE 16 -bit 32 -bit Continuity Discontinuity API No. instruction instruction condition condition 224 LD= DLD= S 1=S 2 S 1≠S 2 225 LD> DLD> S 1>S 2 S 1≦S 2 226 LD< DLD< S 1<S 2 S 1≧S 2 228 LD<> DLD<> S 1≠S 2 S 1=S 2 229 LD<= DLD<= S 1≦S 2 S 1>S 2 230 LD>= DLD>= S 1≧S 2 S 1<S 2 LD= K200 C10 LD D200 K-30 SET Y21