3. Instruction Set Example 1 1. When M0 changes from OFF to ON, the INITC instruction starts to initialize the servos at station addresses 1–3 (should be in a consecutive order), until M1615 is ON. (The station address must start at 1 and the following addresses cannot be skipped or reserved.) 2. When M3 changes from OFF to ON and the target speed of the servo at station address 2 is 3000 rpm, the CASD instruction sets the acceleration time of servo 2 to 3000 ms and the deceleration time to 9000 ms. 3. If the target speed of servo 2 is 1000 rpm, the acceleration time and deceleration time are shown below. Acceleration time: [3000 ms / 3000 rpm] Ч 1000 rpm = 1000 ms Deceleration time:
[9000 ms / 3000 rpm] Ч 1000 rpm = 3000 ms 3-547