DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Example 1 1. When M0 changes from OFF to ON, the INITC instruction starts to initialize the servos at station addresses 1–3 (should be in a consecutive order) The station address must start at 1 and the following addresses cannot be skipped or reserved. Set the acceleration time of servo 1 to 3000 ms and the deceleration time to 9000 ms, until M1615 is ON. 2. When M1615 is ON, the instruction starts enable the servo at station 1 and SM1640 is ON, indicating Servo-ON. 3. When M5 changes from OFF to ON, servo 1 moves at 600.0 rpm until M5 is OFF. 3-556