Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set 13. If M1198 is ON, it means communication errors occur and an error code will be stored in D1176. For other error codes, please refer to the following table. When S 1 +4=0 (UDP mode) When S 1 +4=1 (TCP mode) 3-571 the communication instruction has to be stopped and then start the instruction again to start the communication. D1176 Error code 0 0 R D1227 D1228 During execution of the ETHRS instruction, if it is in the receiving mode, D1227 and D1228 show the sender’s IP address.

(available for ES2-E V1.2, 12SE V1.92, 26SE V2.00) (available for ES2-E with firmware V1.2, or later, 12SE with firmware V1.92 or later, and 26SE with firmware V2.00 or later) 0 - R Error code Description H2003 The value exceeds the range. H600C The local socket has been used. H600D Ethernet network is not connected. H6209 UDP Socket illegal IP address H620A UDP Socket illegal communication mode H620C UDP Socket illegal address for sending data H620D UDP Socket the length of sent data exceeds the range H620E UDP Socket the device where data are sent exceeds the range H620F UDP Socket illegal address for receiving data H6210 UDP Socket the length of data actually received exceeds the range.

H6211 UDP Socket the device where data are received exceeds the range. H6213 UDP Socket the size of data actually received is larger than the set data. H6215 UDP Socket is not connected H6217 UDP Socket connection has been triggered Error code Description H2003 The value exceeds the range. H600C The local socket has been used. H600D Ethernet network is not connected. H6200 TCP Socket illegal IP address