Delta DVP-ES2 — 5.6 IST Instruction

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 5. When S2 (auto mode) is initialized, i.e. selected, auto mode will NOT be executed if M1043 = ON or any of the state between D 1 to D 2 I is ON. Program Example 2: Robot arm control (by IST instruction): 1. Control purpose: Select the big balls and small balls and move them to corresponding boxes. Configure the 2. Motion of the Robot arm: control panel for each operation. lower robot arm, clip balls, raise robot arm, shift to right, lower robot arm, release balls, raise robot arm, shift to left to finish the operation cycle. 3.

I/O Devices Right-limit X2 (big balls) Right-limit X3 (small balls) Left-limit X1 Y0 Upper-limit X4 Y2 Y3 Y1 Upper-limit X5 Big Small Ball size sensor X0 4. Operation mode: Single step: Press single button for single step to control the ON/OFF of external load. Zero return: Press zero return button to perform homing on the machine. Auto (Single step / One cycle operation / Continuous operation):  Single step: the operation proceeds with one step every time when Auto ON is pressed.  One cycle operation: press Auto ON at zero position, the operation performs one full cycle operation and stops at zero point. If Auto OFF is pressed during the cycle, the operation will pause.

If Auto ON is pressed again, the operation will resume the cycle and stop at zero point.  Continuous operation: press Auto ON at zero position, the operation will perform continuous operation cycles. If Auto OFF is pressed, the operation will stop at the end of the current cycle. 5-24