DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Editing the Ladder Diagram through WPLsoft When M0=ON, DVP-ES2-C sends out the first request message and D6000 should be 101(hex) after the response message is transmitted back successfully. In program, if the value of D6000 is judged as 101(hex), the ReqID is changed into 2 and D6250 is given a new value 201(hex) and DVP-ES2-C sends out the request message again. By dong so, the real-time reading can be realized. After reading succeeds, the data returning from the target device are stored in D6000~D6005. The value of D6005: 100 ( hex ) is the read value of P0-09. Explanation of Response Message Devices:
7.5 Indicators and Troubleshooting There are 6 LED indicators on DVP-ES2-C. Power indicator shows whether the power is normal, RUN and ERROR indicator display the state of running of internal program and COM3 displays the communication state of CANopen.
7.5.1 Description of Indicators POWER indicator 7-22 Content Explanation PLC device (Hex) High byte(Hex) Low byte(Hex) SDO response message mapping area D6000 0101 ResID = 01 Status code = 01 D6001 0008 Reserved Size = 08 D6002 4302 Type = 43 Node ID = 02 D6003 2009 Main index high byte = 20 Index low byte = 09 D6004 0004 Reserved Subindex = 00 D6005 0100 Datum 1= 01 Datum 0= 00 D6006 0100 Datum 3= 00 Datum 2= 00 LED indicator Description How to deal with Light is off or the green light flashes The supply power is abnormal Check if the supply power is in the valid range The green light keeps on The supply power is normal No resolution is required