DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming As a master, DVP-ES2-C supports maximum 16 slaves ranging from node 1 to node 16. D9998 can be used for monitoring the state of nodes from 1 to 16 in the network. And the 16 bits of D9998 corresponds to 16 slaves and the corresponding relations of them are shown below. When the node in the master node list is normal, the corresponding bit is OFF; when the node in the master node list is abnormal (E.g. Initializing fails or slave is offline due to other abnormality), the corresponding bit is ON.
The error code of every node is displayed through the corresponding special register and the relations between special register and corresponding node are shown below. Code display in D9981~D9996 as DVP32ES2-C is in master mode: Code display in D9980 as DVP-ES2-C is in master mode: 7-24 D9998 Used for monitoring the state of the entire CANopen network D9999 Used for displaying a CAB baud rate K1: 20K; K2: 50K; K3: 125K; K4: 250K; K5: 500K; K6:
1M (Only applicable to DVP-ES2-C V3.26 (and above)) Bit b7 b6 b5 b4 b3 b2 b1 b0 Node Node 8 Node 7 Node 6 Node 5 Node 4 Node 3 Node 2 Node 1 Bit b15 b14 b13 b12 b11 b10 b9 b8 Node Node16 Node15 Node14 Node13 Node12 Node11 Node10 Node 9 Special D9981 D9982 D9983 D9984 D9985 D9986 D9987 D9988 register Node Node 1 Node 2 Node 3 Node 4 Node 5 Node 6 Node 7 Node 8 Special D9989 D9990 D9991 D9992 D9993 D9994 D9995 D9996 register Node Node 9 Node10 Node11 Node12 Node13 Node14 Node15 Node16 Code Indication How to correct E0 DVP-ES2-C master module receives the emergency message sent from slave.
Read the relevant message via PLC program E1 PDO data length returned from the slave is not consistent with the length set in the node list. Set the PDO data length of slave and re-download them. E2 PDO of slave is not received. Check and ensure the setting is correct. E3 Downloading auto SDO fails. Check and ensure auto SDO is correct. E4 Configuration of PDO parameter fails. Ensure that the PDO parameter setting is legal. E5 Error in key parameter setting. Ensure that the actually connected slave is consistent with the configured slave. E6 The slave does not exist in the network Ensure that the supply power of slave is normal and the connection in the network is proper.
E7 Slave error control is timed-out. E8 The node IDs of master and slave repeat. Set the node ID of master and slave again and ensure their node IDs are sole. Code Indication How to correct F1 Slave has not been added to node list of CANopen Builder software Add slave into the node list and then re-download the configured data. F2 The data are being downloaded to DVP-ES2-C Wait to finish downloading the configured data. F3 DVP-ES2-C is in error status Re-download parameter configuration F4 Bus-off is detected. Check if CANopen bus cables are properly connected and ensure that all the node devices run at the same baud rate before