DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 1> When “CANopen Slave” displays in the Name column, it indicates that PLC is in the mode of CANopen slave. At that time, select “Simulated online” on the bottom left side on the page and finally click “OK” to start the online scanning. 2> When “CANopen Master” displays in the Name column, it indicates that PLC is in the mode of CANopen master. At that time, directly click “OK” to start the online scanning. 4) Click “Network”> “Master Parameter” and the following “Master configure…” dialog box appears. According to actual requirement, user can set the CANpen Node ID, baud rate and master/slave mode of DVP-ES2-C.
7-28 Item Explanation Default Node ID The node ID of DVP-ES2-C on the CANopen network 17 Baud rate CANopen communication rate 1M bit/second Work mode CANopen master/slave mode Master Cycle period The cycle time for sending one SYNC message 50ms Master’s heartbeat time The interval time for sending the master heartbeat message 200ms