DVP-ES3 Series Programming Manual 9. For PLC with FW V1.06.00 (V1.06.00 included) or later: If S 6 is set to 0 after the mark signal is received, it means that the ramp-down stop is performed based on the ramp-down time. If S 6 is set to -1 after the mark signal is received, it means that the output immediately stops. If S 6 is set to >0 after the mark signal is received and if the setting value of S 6 is not enough to achieve the ramp-down stop within the ramp-down time, the instruction limits the target frequency and performs the ramp-down stop in accordance with the set ramp-down time.
If S 6 is greater than the number of pulses output within the ramp-down time, the instruction outputs the number of redundant pulses with the same output frequency when the interrupt is triggered, and then performs the ramp-down process. _6 Added new SR652, SR653 for displaying number of pulse in ramp-up area and new SR654, SR655 for displaying number of pulse in ramp-down area. 6-812 ramp-down time If S6 is greater than the number of pulses output within the ramp-down time, The instruction outputs the number of redundant pulses with the same output frequency when the interrupt is triggered, and then performs the ramp-down process S6:
the number of output pulses in the ramp-down Description If S6 = > 0 after the mark signal is received If the setting value of S6 is not enough to achieve the ramp-down stop within the ramp-down time, The instruction limits the target frequency and performs the ramp-down stop in accordance with the set ramp-down time If S6 = > 0 after the mark signal is received If S6 is greater than the number of pulses output within the ramp-down time, The instruction outputs the number of redundant pulses with the same output frequency when the interrupt is triggered, and then performs the ramp-down process If S6 is set to 0 after the mark signal is received the ramp-down stop is performed based on the ramp-down time If S6 =-1 after the mark signal is received the output immediately stops If S6 = The instruction does NOT limit the target frequency and after outputting the number of output pulses, the output stops immediately If S6 = The instruction outputs the number of redundant pulses with the same output frequency when the interrupt is triggered, and then performs the ramp-down process