Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions Example (Ladder diagrams) 1. Draw a rhombus as shown below. Y 軸 (0,0) X 軸 (-27000,-27000) (27000,-27000) (0,-55000) 2. Steps:  Set the coordinates of four points (0, 0), (-27000, -27000), (0, -55000), (27000, -27000) as in the figure above. Calculate the relative coordinates of the four points and obtain (-27000, -27000), (27000, -28000), (27000, 28000), and (-27000, 27000). Place them in the 32-bit registers (D200, D202), (D204, D206), (D208, D210), (D212, D214).  RUN the program in the PLC. Set M0 to ON to start the 2-axis line drawing. 6_ 6-821