Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

DVP-ES3 Series Programming Manual 3. S 4 sets the target frequency for the reference. The target reference frequency is used for the prior calculation when the PLC plans the travel path for the arc after the instruction is executed. But if the estimated calculation process cannot achieve the arc travel path, the output frequency is automatically decreased to fulfill the synchronized arc drawing function. 4. S 5 is the setting value for function selection. See the descriptions below. _6 5. Refer to Example 2 of the DPPMR instruction for more details on ST language programming. 6-828 Setting value in S5 S3 :

The shift of the center or central angle Description 0 Shift of the center (32-bit integer type) The arc resolution uses a 10° arc as the basic angle for motion. 1 Shift of the center (32-bit integer type) The arc resolution uses a 5° arc as the basic angle for motion. 2 Shift of the center (32-bit integer type) The arc resolution uses a 1° arc as the basic angle for motion. 10 Shift of central angle (floating point type) The arc resolution uses a 10° arc as the basic angle for motion. 11 Shift of central angle (floating point type) The arc resolution uses a 5° arc as the basic angle for motion.

12 Shift of central angle (floating point type) The arc resolution uses a 1° arc as the basic angle for motion. Other Shift of the center (32-bit integer type) Seen as setting value in S5 is 0 The arc resolution uses a 10° arc as the basic angle for motion.