Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions 7. The execution sequence is based on the value of the low 16-bit code in the table above, and described below.  The direction of DOG signal is determined by the value of bit 5.  The NL negative limit and DOG signal are determined by the value of bit 5 and bit 4.  Mode 0 or mode 1 for the zero point return, selected according to the value of bit 3.  The operation of the zero point return is performed according to the values of bit 1 and bit 0. 8. The Completion flag is set to ON after the instruction finishes performing the specified function.

For example, for function code 2, the PLC sets the Completion flag to ON only when the number of specified pulses completes outputting. 9. After the DZRN2 instruction is executed, an interrupt service program is not executed till the DZRN2 instruction is 6_ disabled, if the specified input point for the zero point is the same as that for the external input interrupt in the program. 10. The instruction cannot be used in the ST programming language, interrupt tasks or function block which is called only once. 6-869 Functions Code Description High Low 16-bit 16-bit that the motion is in the negative direction.

DOG point is B point +16 (bit4=ON) When in the low 16-bit code, bit 4 is ON, it means the zero point is ON as the DOG point changes from ON to OFF and the zero point is left as the DOG point changes from OFF to ON. NL point is B point +32 (bit5=ON) When in the low 16-bit code, bit 5 is ON, it means the zero point is ON as the NL point changes from ON to OFF and the zero point is left as the DOG point changes from OFF to ON.