Delta DVP-ES3 — 6.27.2 Explanation of CANopen Communication Instructions

DVP-ES3 Series Programming Manual 3. For S 3 and S 4 , refer to the object dictionary in the Delta servo / inverter operation manual or the object dictionary from a third-party device that complies with CANopen DS301. 4. You should execute the COPRW instruction only after the INITC instruction is complete in case the parameters are overwritten by the INITC instruction. Use the COPRW instruction for CANopen SDO communication. If the station address of a slave exceeds the range 1–8 or 21-28, you can use the COPRW instruction to set, read, and write slave-related parameters. 5. SM1682 is set to ON when an error occurs during communication.

In addition, SR658 retains the number of the axis _6 in which the error occurs and SR659 retains the error code. Refer to DRVIC instruction for details. Note: When you use the COPRW instruction, you must edit the process for dealing with communication errors in order to avoid invalid communication occurring as a result of unexpected communication errors. 6. The diagram below shows the timing of the COPRW instruction.  When you enable the COPRW instruction for the first time, the instruction sends the command code immediately if no other CANopen communication is using it.  The instruction sends the command code.  The code has been sent and the finish flag is set to ON.

 You modify the next data to be sent out. The next command code is sent out immediately after the finish flag is set to OFF.  The code has been sent and the COPRW instruction is disabled. 6-902 S2 (only available for Description values of lower 8-bit) 16#0023 Writing the 4-byte data; Expedited SDO 16#002B Writing the 2-byte data; Expedited SDO 16#002F Writing the 1-byte data; Expedited SDO 16#0040 Reading the data. The data length is contained in the SDO response message; Expedited SDO 16#0021 Data and its length are specified by S5; Normal SDO 16#0041 Reading the data and store the read data and its length in S5; Normal SDO