Chapter 6 Applied Instructions ramp-down time are affected by the scan time. If you require accurate ramp-up or ramp-down time, it is recommended that you use an output instruction with specified ramp up or ramp down time such as the DDRVI instruction (API 2706). 4. The range of the target output frequency S 2 is between -200 kHz to 200 kHz. If the setting value is out of the range, the PLC processes it as the minimum or maximum output value. A positive number for the output frequency indicates forward output. A negative number for the output frequency indicates reverse output. 5. D 1 allows only Y0–Y7 for the output point.
For the auxiliary output point specified by D 2 , refer to the output points in the following table. If you choose other output points or the M device, the value in SR indicating the output mode is invalid and the Pulse+direction mode is valid by default. D 2 is a direction output point. D 1 selects the even output point number. 6_ D 1 selects the odd output point number. 6. If SR=0, it indicates the Pulse+direction output mode. If SR=1, it indicates the A/B phase output mode. Note: you can select the output mode only when D 1 uses an even output point and D 2 uses a recommended direction output point. 7.
When the direction outputs are not using the default outputs to output, you can refer to the table below for setting up the outputting time that pulse outputting goes first before direction outputting does. So that you can be sure the outputting only happens when switching to the direction outputs. The unit for SR is millisecond and the range is 0-20 ms. Default is 0, indicating inactive.
6-775 Output point for D1 Y0 Y2 Y4 Y6 Direction output point for D2 Y1 Y3 Y5 Y7 Busy flag SM460 SM480 SM500 SM520 Output mode SR462 SR482 SR502 SR522 Present output position SR460 SR461 SR480 SR481 SR500 SR501 SR520 SR521 Output point for D1 Y1 Y3 Y5 Y7 Direction output point Y20 or above or any M device (BOOL) for D2 Busy flag SM472 SM492 SM512 SM532 Present output SR474 SR475 SR494 SR495 SR514 SR515 SR534 SR535 position