EA180 Series Servo Drive Users Manual Chapter 2 Installation 2.1 Notes for installation Please pay attention to the following points: The cable between the servo drive and servo motor should be kept loose. If the cable between the servo drive and servo motor exceeds 20 meters, please thicken the UVW cables and the encoder cable. When fixing the servo drive, the installation direction must follow the instructions, and each fixing screw must be firmly fastened. Make sure the servo motor shaft is concentric with the equipment shaft to prevent radial stress during operation. The four fixing screws of the servo motor must be fastened according to the specified torque.
In order to have a good cooling effect, when installing the AC servo drive, please keep enough space between the device and adjacent articles and baffles (walls) around it, otherwise faults may be caused. The servo drive shall not be toppled and placed during installation, and its suction and exhaust holes shall not be blocked, otherwise faults may be caused. 2.2 Environmental conditions for storage Please put this product in its packing box before installation. If the servo set is not used for the time being, in order to make the product conform to the warranty scope and requirements for future maintenance of SINEE, the following matters must be paid attention to during storage:
2.3 Environment conditions for installation 2.3.1 Operating conditions of EA180 servo drive 2.3.2 Operating conditions of servo motor Do not use the motor in a closed environment. Closed environment will lead to high temperature of motor and shorten its service life. 2.3.3 Other notes In addition to the above environmental conditions, no matter the servo drive or motor, please follow the following instructions when selecting the installation location, otherwise the product may not meet our warranty scope and future maintenance requirements:
14 Item Description Ambient temperature -20 ℃ ~ + 65 ℃ Ambient humidity Relative humidity 20%～90% (no condensation) Vibration Below 49m/s² Shock Below 49m/s² Item Description Dust and gas The device must be installed in a dust-free environment without corrosive gases or liquids. Ambient humidity Relative humidity 20%～90% (no condensation) Ambient temperature 0 ℃ ~ + 45 ℃ Vibration Below 49m/s² Shock Below 49m/s² Altitude Below 1000m; if above 1000m, please derate the device Item Description Ambient humidity Relative humidity 20%～90% (no condensation) Ambient temperature 0℃～+40℃ Vibration Below 49m/s² Shock Below 49m/s² Altitude Below 1000m; if above 1000m, please derate the device