EA180 Series Servo Drive Users Manual 4.2 Overview of drive operating modes EA180 servo drives have seven operating modes: The modes are switched as follows: 4.3 Initialization mode It After the drive control boards (L1C and L2C) are powered on for the first time or reset by AF-00 software, they first enter the initialization mode, display EA180 , and automatically enter the status monitoring mode in 1 second. 4.4 Status monitoring mode St After the system initialization, it will automatically enter the status monitoring mode in 1 second:
43 Operating Mode Menu Display Levels Function Name Sign Level 1 Lev el 2 Level 3 Initialization mode It Display drive model - EA180 - Status monitoring mode St Show current drive status - -Prdy - Parameter monitoring mode d0 Select monitoring parameters and monitor their values D0-00 - 100 - Parameter setting mode Pr Select a parameter and change its value p0-00 1 -End- Auxiliary function mode AF Select an auxiliary function and perform corresponding operations AF-05 jIdt jIdt Changed parameter mode (hidden by default) CG Check all parameters that differ from the default values (Check with auxiliary function AF-08=1, which the information will be hidden again after power-on again) p1-00 0 - Warning and alarm Mode (displayed in case of exception) Al Display warnings and alarm information - AlE03 - Control panel power-on Initialization mode Sho It EA180 Status monitoring w 1S mode st Initialization -Prdy normal M System stay state AF-08=0 Parameter monitoring mode dS D0-00 M Parameter mode changed Cg p0-00 Parameter setting mode pr AF-08=1 p0-00 M Auxiliary function and mode AF AF-00 Warning or alarm occurs M Failure and warning mode Al AlE03 Warning/alarm clearing comm Sho w 1S AF-0 8=0 Auxiliary function mode AF-00 AF