EA180 Series Servo Drive Users Manual When selecting the monitoring parameter dx-yz, please select the group number (x) first, and then select the intra-group number (yz, z can be carried to y). The Shift button S controls the cursor to move rightward circularly in the first-level interface of this mode, and the position change route is LED0 (initial position)→ LED3→LED1→LED0 …; in this mode, the second-level interface controls the data of the first and second screens to be displayed back and forth. The monitoring parameter value can be checked more easily.
If the current interface is the second level in this mode, press ˄ button to directly switch to the first-level interface display of the next parameter (equivalent to M + ˄ ); you can press the ˅ button to directly switch to the first-level interface display of the previous parameter (equivalent to M + ˅ ); In this mode, when the first-level interface is displayed, you can press S button to directly enter the second-level interface. If there is no key operation for more than 2s, it will automatically enter the second-level interface for display.
4.6 Parameter setting mode pr After the system initialization, it will automatically enter the status monitoring mode; press M button twice to switch to the parameter setting mode. The following is an example of setting P1-01=2, Pb-01=1 and returning to P1 group parameters.
Status monitoring mode Parameter monitoring mode D0 - 00 M p0 - 00 ˄ ＜ Level 1 p1 - 00 ＜ Set P1-01 p1 - 00 p1 - 00 ˄ p1 - 01 p1 - 01 ＜ S ˄ Multiple times p1 - 01 pb - 00 pb - 00 Multiple times ＜ Multiple times ˄ S Set Pb-01 pb - 02 ＜ pb - 02 pb - 02 M ˄ Multiple times When selecting the setting parameter Px-yz, please select the group number (x) first, and then select the intra-group number (yz, z can be carried to y); Return to P1 group p1 - 01 When selecting a group, the last operated intra-group number will be automatically displayed (if returning to Group P1 again, P1-01 will be directly displayed).
The Shift button ＜ controls the cursor to move rightward circularly in the first-level interface of this mode, and the position change route is LED3 (initial position)→LED1→LED0→LED3 …; in the second-level interface of this mode, it controls the cursor to move leftward circularly, and the position change route is LED0 (initial position)→LED1→LED2→LED3→LED4→ (second screen LED0→second screen LED1→second screen LED2→second screen LED3→second screen LED4)→LED0→LED1....
The leftmost position of the cursor is determined by the number of bits displayed by the current parameter; When entering the parameter setting mode from other modes, the cursor stops at LED3 by default; When pressing M or S button to enter the first level from the second level of this mode, the cursor stops at LED0 by default; When entering the second level of a parameter, its current value will be automatically cached and displayed. At this time, after the value is changed through other channels (such as communication), the display will not be automatically refreshed.
After changing the parameters with the buttons, press the M button to return to the first level, and 46 Initialization Normal -.Prdy meter setting mode Level 2 ˄ S 0 3 M Multiple times 1s aft 1 ＜ ˄ S 01 11 1s a -End- fter display -End-