EA180 Series Servo Drive Users Manual the parameter remains the value before the change; After changing the parameters with the buttons, press the S button to confirm the setting; show the third level for 1s and automatically return to the first level, and the parameter will be set to the new value. After setting the parameter and pressing S button, whether the current parameter is valid immediately and what is displayed at the third level is related to the parameter attribute. 4.7 Changed parameter mode Cg After each power-on of the control panel, the changed parameter mode defaults to be hidden. You need to set AF-08=1 and switch to this mode with the M button.
Below is the description in two cases: No function code and different from the factory set value: When entering the changed parameter mode, the LED displays null . Auxiliary function mode Level 1 Level 2 AF - 08 1 M Changed parameter mode null The following function codes (P1-00/P1-02/P9-08/P9-13/P9-14) are different from the factory set values: A. In order to distinguish from the normal function display, "-" flashes at LED2; B. Find the changed function code with ˄ or ˅ button; C. The monitoring parameter value can be changed more easily.
If the current interface is the second level in this mode, press ˄ button to directly switch to the first-level interface display of the next parameter (equivalent to M + ˄ ); you can press the ˅ button to directly switch to the first-level interface display of the previous parameter (equivalent to M + ˅ ); D. Only the current changed value can be viewed when entering the second level. Parameter changes in this interface are not supported. 47 Parameter Display after Description attribute pressing S ○ -End- Set at any time, valid immediately ● Po-on The values before and after change are different:
Set at any time, and valid the power-on again -End- The values before and after change are the same: The initial value is always valid. ☆ Halt The values before and after change are different: Set at any time, and valid after the motor is static for 1s. -End- The values before and after change are the same: The initial value is always valid. ▲ - Read-only