sinee — EM303B User Manual

User Manual EM303B General Purpose Inverter 13.5.4 CRC Parity Sending equipment calculates CRC parity value first, and then attaches it to the sending message. Upon receipt of the message, receiving equipment will calculate CRC parity value again, and compare the operation result with received CRC parity value. If the two values are different, it indicates that there is error during transmission. Calculation process of CRC parity: 1. Define a CRC parity register, and initialize it as FFFFH. 2. Conduct XOR calculation between the 1 st byte of sending message and the value of CRC parity register, and then upload the result to CRC parity register.

Start from address code, the start bit and stop bit will not be calculated. 3. Collect and check LSB (the least significant bit of CRC parity register). 4. If LSB is 1, shift each bit of CRC parity register rightwards by 1 bit, the highest bit filled with 0. Conduct XOR calculation between the value of CRC register and A001H, and then upload the result to CRC parity register. 5. If LSB is 0, shift each bit of CRC parity register rightwards by 1 bit, the highest bit filled with 0. 6. Repeat steps 3, 4 and 5 until completing 8 rounds of shifting. 7. Repeat steps 2, 3, 4, 5 and 6, and process the next byte of sending message.

Repeat above process continuously until each byte of sending message is processed. 8. CRC parity date will be saved in CRC parity register after calculation. 9. LUT (Look-up table) method is to obtain CRC parity in the system with limited time resources. Simple CRC functions as shown in following (C language Programming): unsigned int CRC_Cal_Value(unsigned char *Data, unsigned char Length) { unsigned int crc_value = 0xFFFF; int i = 0; while(Length--) { crc_value ^= *Data++; for(i=0;i { if(crc_value & 0x0001) { crc_value = (crc_value>>1)^ 0xa001; 180 2006H.

Name Address Description Control 40xx/70xx Refers to 12.6 description of control command Command Working 41xx Refers to 12.6 description of control command Status