EM500 Open-Loop Vector Control Inverter User Manual 196 26 Set Time Reach When the timed running time is reached, present output is active. Otherwise, present output is inactive. See F16.09 for details. 27 Zero Speed Running When inverter is in JOG or slave running status, and output frequency (F18.00) ≤ zero servo start frequency (F04.29), present output is active. Otherwise, present output is inactive. 28~48 Not Used 38 Off Loading The inverter is in the Loss Of Loading state 49 Inlet Valve Control Air compressor dedicated function, this function is used to control the air compressor inlet valve.
50 Fan Start-stop Control Signals Air compressor dedicated function, this function is used to control the air compressor start and stop 51 Phase Angle Of Arrival Phase Sequence Phase Detection Card-specific function, which is used to indicate that the set phase angle difference has been reached. 52 Inverter Startup Is Completed Phase sequence phase detection card special function, when using a phase-sequence phase detection card function, this function is used to control the output of the inverter circuit.
53 Switch to The Power frequency Phase sequence phase detection card special function, when using a phase-sequence phase detection card function,, This function is used to control the contactor of Power frequency switch to 54~55 Not Used 56 Pipeline Overpressure Alarm Water supply application-specific function, when the pipeline is meet the over-pressure conditions, the terminal output is valid 57 Under-voltage Alarm Water supply application-specific function, when the pipeline is meet the under-pressure conditions, the terminal output is valid 58 Water Shortage Alarm Water supply application-specific function, When it have Inlet pool water level control, and includes lack of water level switch, disconnect the lack of water level switch ,the output function is valid.
59 Dormancy Instructions Water supply application-specific function, This function output is valid when the water pump meets the sleep