sinee — 7.4 F03 Group: Output Terminal Function Parameter

EM500 Open-Loop Vector Control Inverter User Manual If the two multi-function output ports are of OC output type and the common terminal of the output is COM. If the selected function is inactive, the electronic switch is OFF; if the selected function is active, the electronic switch is ON. OC can be powered by internal power supply, as shown in Figure 7-12 (a), or by external power supply, as 197 condition and sleep is completed.

60 The Pump Rotation Instructions Water supply application-specific function, This function output is valid when the rotary pump to meet ahead of the output 61 The Standby Pressure Operation Instructions Water supply application-specific function, This function output is valid when the Inlet pool water level control is effective and water level given is standby pressure 62 Not Used 63 H Pump Control Water supply application-specific function, This function output is valid when the H pump is action 64 I pump control Water supply application-specific function, This function output is valid when the I pump is action 65~66 Not Used 67 Brake Control Winding application-specific function, the function output is valid when the brake is valid, 68 Material supply disruptions Detection Output Winding application-specific function, the function output is valid when the Material supply disruptions is happened 69 FDT1 Lower Bound (Impulse) The function is similar to 3/4 ,The difference is that the output is valid only after the frequency is lower than the "set-hysteresis" and is automatically disabled for keep a period of time.

If set to monopulse output, the time is set by F03.17 ~ F03.20; if the output is level of output, the time defaults to 0.1s. 70 FDT2 Lower Bound (Impulse) 71 FDT1 Lower Bound (Impulse When JOG Is Invalid) The function is similar to 69/70, The difference is that the output is invalid in JOG 72 FDT1 Lower Bound (Impulse When JOG Is Invalid)