EM500 Open-Loop Vector Control Inverter User Manual The function UP/DOWN can be classified into the keypad UP/DOWN and the terminal UP/DOWN, which can be enabled individually and simultaneously Keypad UP/DOWN: Only enabled at the level 0 monitoring menu, which is under control of clockwise rotation of digital potentiometer and counter clockwise rotation of digital potentiometer on the keypad. Under the monitoring menu clockwise or counter clockwise rotation of digital potentiometer the offset frequency increases/decreases at the rate set through F12.10; at this time, the keypad displays “F18.01:
Set Frequency” and the final frequency is the sum of the set frequency and the offset frequency. After releasing the button for 2s, the keypad displays normally. Terminal UP/DOWN: By setting the numeric input terminal as corresponding When the terminal UP/DOWN is on, the offset frequency increases/decreases at the function, inverter is under terminal control. rate set through F12.10 and the final frequency is the sum of the set frequency and the offset frequency.
★ When the keypad UP and the terminal down (or the keypad DOWN and the terminal UP) are enabled at the same time, the offset frequency fluctuates due to different valid time points, although the acceleration/deceleration speed does not change. It is a normal phenomenon. EM500 inverter has a kilowatt-hour meter function (refer to the descriptions of F18.18 and F18.19). User may set present function code as 1 to clear present count 268 F12.12 Power Failure Save of UP/DOWN Offset 0: Disabled 1: Enabled (only at modified offset) 0 〇 No. Function Range Unit Default Type F12.13 Kilowatt-H our Meter Clear 0: Not to Clear 1: Clear 0 ● No. Function Range Unit Default Type F12.14 Reset 0:
No Autotuning 1: Reset (exclusive of motor parameter, inverter parameter, 0 〇