EM500 Open-Loop Vector Control Inverter User Manual F13.08=0: Set through F13.09 Under torque control mode, the upper limit frequency is set through F13.09. F13.08=1: AI1 F13.08=2: AI2 F13.08=3: AI3 F13.08=4: AI4 (Expansion Card) (percentage) * F13.09 Under the torque control mode, the upper limit frequency is set through AI F13.08=5: High-Frequency Pulse Input (X7) Under the torque control mode, the upper limit frequency is set through HDI (percentage) * F13.09 X7. F00.04 has the same meanings as AI1-AI4 and X7.
100.00% is the percentage Please refer to the description of F00.04 for detailed explanations of AI1-AI4 and inputted through F13.09 (Upper Limit Frequency of Torque Control) F13.08=6 or 7: Communication Setting of Torque Control Upper Limit Frequency For master-slave communication (F10.05=1) and the inverter is slave (F10.06=0) the upper limit frequency is 700FH (Communication Setting) * F10.08 (proportional coefficient) * F00.18 (upper limit frequency). The range of 700FH is 100.00% to 276 5: High-Frequency Pulse Input (X7) 6: Communication Percentage Setting 7:
Direct Communication Setting F13.09 Upper Limit Frequency of Torque Control 0.00 - Maximum Frequency F00.16 Hz 50.00 ● F13.10 Upper Limit Frequency Offset 0.00 - Maximum Frequency F00.16 Hz 0.00 ● F13.18 Reverse speed limit 0~100 % 100 ● F13.19 Reverse torque limit 0~1 1 ●