sinee — 7.18 F17 Group: Virtual I/O Function Parameter

EM500 Open-Loop Vector Control Inverter User Manual Phase sequence phase detection card is an independent function, not associated with industry applications. After using the phase sequence phase interface card The inverter can realize synchronous motor soft start after switching to power frequency. 1. After installing the optional card, you need to set F 16.12 to enable the corresponding function. Please set F16.12 and then power off when installed for the first time, then you can install the optional card. 2. Please replace the interface card after the LED light of the inverter turns off 3.The phase sequence phase detection card is only applied to the synchronous motor 7.18 F17 Group:

Virtual I/O Function Parameter functions and use methods are basically the same as actual input terminals. In the EM500 inverter has 8 multi-function virtual input terminals (VX1 - VX8). Their following, only the difference will be described. For the same functions and use methods as that of actual input terminals, please refer to the descriptions of F02 Input Terminal Function Parameters. 299 No.

Function Range Unit Default Type F17.00 VX1 Virtual Input Function Same as the options of F02 group numeric input terminals, please refer to Table 7–2 Functions of Numeric Multi-Function Input Terminals 0 〇 F17.01 VX2 Virtual Input Function 0 〇 F17.02 VX13Virtual Input Function 0 〇 F17.03 VX4 Virtual Input Function 0 〇 F17.04 VX5Virtual Input Function 0 〇 F17.05 VX6 Virtual Input Function 0 〇 F17.06 VX7 Virtual Input Function 0 〇 F17.07 VX8 Virtual Input 0 〇