sinee — 7.20 F19 Group: Fault Record Parameter

EM500 Open-Loop Vector Control Inverter User Manual Ч For various fault types of EM500, see Table 7-22 below: Table 7-22 Fault Types 309 7-23 Running Modes at Fault. F19.17 Working Time at Fault Used to display the working time at the last two faults. h 0 Fault type Keypad Fault type Keypad display display 0: No Fault 0 SC: Output Short Circuit Protection SC HOC: Instantaneous Overcurrent HOC HOU: Instantaneous Overvoltage HOU SOC: Stable Overcurrent SOC SOU: Stable Overvoltage SOU SIU: Stable Undervoltage SlU IlP: Input Phase Loss IlP OlP: Output Phase Lose OlP Ol: Inverter Overload Ol OH: Inverter Overheating Protect OH E11: Parameter Setting Conflict E11 E12: Motor Overheating E12 E13:

Motor Overload E13 E14: External Fault E14 E15: Inverter EEPROM Fault E15 E16: Communication Abnormality E16 E17: Temperature Sensor Abnormality E17 E18: Soft Start Relay Off E18 E19: Current Detection Circuit Abnormality Abnormality E19 E20: Stall Fault E20 E21: PID Feedback Disconnection E21 E22: Not Used E22 E25: Motor Overspeed Protection E23 E24: Parameter Autotuning Abnormality E24 E25: Not Used E25 E26: Offload Protection E26 E27: Accumulated Power-On Time Reach E27 E28: Accumulated Running time Reach E28 E29: Internal Communication Fault E29 E30: Not Used E30 E31: Not Used E31 E32: Not Used E32 E33: CANopen Communication Overtime E33 E34:

DeviceNET without Network Power Supply E34 E35: DeviceNET BUS-OFF E35 E36: DeviceNET MACID Detection Failure E36 E37: DeviceNET IO Communication Overtime E37