EM500 Open-Loop Vector Control Inverter User Manual For running modes of EM500 at fault, see Table 7-23: Table 7-23 Running Modes at Fault 7.21 F25 Application of water supply basic groups Water supply application included F25 / F26 function codes, F25 group is application of 310 E38: DeviceNET IO Mapping Error E38 E39: Profibus-DP Parameterization Data Error E39 E40: Profibus-DP Configuration Data Error E40 E41: Profibus-DP IO Disconnection E41 E42: Not Used E42 E43: Material supply disruptions Error E43 E44: Winding traverse Error E44 E45:Air pressure over voltage Error E45 E46: Air pressure feedback Disconnection E46 E47: Oil Temperature Over-temperature Error E47 E48:
Oil Temperature Feedback Disconnection E48 E49: Motor Over-temperature Error E49 E50: Motor Temperature Feedback Disconnection Error E50 E51: It's Time To Mechanical Maintenance E51 E52~E55: Not Used E52~E55 E56: Pump Error E56 E57: Pipe networks Overpressure E57 E58: Pipe networks Undervoltage E58 E59: water supply tank Water shortage E59 E60: Not Used E60 E61: CANSinee Communication Timeout E61 Keypad Running Mode display 0 Not Running 1 Forward Acceleration 2 Reverse Acceleration 3 Forward Deceleration 4 Reverse Deceleration 5 Forward Constant Speed 6 Reverse Constant Speed