EM500 Open-Loop Vector Control Inverter User Manual M Pump H M Pump I M Primary motor F25.00=0: The basic mode of constant pressure water supply Select the basic constant pressure water supply mode, you can restore to basic water supply parameters by manually resetting F12.14 factory defaults. F25.00=1:Not Used Function not used. 312 EM500 X 1 1 - RUN X3 9-Coast to stop X7 110-External Overpressure sig COM 10V AI1 Setting GND AI2 Pressure feed GND Y 1 9 -Fault Y 2 59 - Dormancy in 24 V E EA 63 -H pump C R RA 64- I pump C P Clock card EC- TM- A 1 CR2032 No.
Function Range Unit Default Type F25.00 Run Mode Selection 0:The basic mode of constant pressure water supply 1:Not Used 0 〇 Function code Explain 0:Application of Water supply After setting F 16.00 = 1, and choose to use mode, restore factory settings. The application parameters are automatically set to the following default values. Basic parameters (motor parameters need to be set manually, conduct static autotuning of motor parameters, and rotation autotuning for synchronous motor is recommended)