sinee — 7.24 F28 Air Compressor Application

EM500 Open-Loop Vector Control Inverter User Manual is active, the inverter will coast to stop. Run command will not work when the brake control terminal is effective. If F 27.26 is set to 0.0, the brake control terminal remains active and can be reset by the brake reset terminal or the fault reset terminal. F27.27 ~ F27.29 are valid when an input terminal is set to 122- traverse detection signal. When the inverter output frequency reaches the set value of F27.27, traverse starts. If traverse detection terminal is judged as invalid in the time of F27.28, then the traverse switch fails. If traverse detection terminal is always active during the time of F27.29, then the traverse arm stops.

When the traverse arm is detected faulty, the inverter will report E44 error and coast to stop. This code is used to set the filter time for material supply disruptions detection, effective for both automatic detection and external detection. This code is used to check the current feedforward gain 7.24 F28 Air Compressor Application 337 No. Function Range Unit Default Type F27.27 Traverse detection minimum frequency 0.00~20.00 Hz 10.00 ● F27.28 Traverse signal invalid judge time 0.1~20.0 s 10.0 ● F27.29 Traverse signal effective judge time 0.1~20.0 s 2.0 ● No. Function Range Unit Default Type Material supply disruptions F27.30 1~100 s 5 ● Detection of filtering time No.

Function Range Unit Default Type The current F27.36 feedforward gain -500.0~500.0 % XXX × value No. Function Range Unit Default Type 0: Application of air compressor F28.00 Application macro 0 〇 all-in-one macros