sinee — 8.3 Steps of Autotuning

EM500 Open-Loop Vector Control Inverter User Manual autotuning for motor. For permanent-magnet synchronous motor  By setting F01.34=11, and pressing RUN , inverter starts stationary autotuning for motor. Or by setting F01.34=12, and pressing RUN , inverter starts rotational It takes about 2 minutes to complete the autotuning and, afterwards, keypad returns to the initial power-on status.  By pressing STOP RESET in autotuning, it will display “E24” parameter autotuning abnormality. By pressing If autotuning fails, inverter will display “E24” parameter autotuning abnormality. By STOP RESET , inverter will return to parameter setting status.

pressing STOP RESET , inverter will return to parameter setting status. 354