sinee — 7.2 F01 Group: Motor 1 Parameter

EM600 High-Performance Vector Control Inverter User Manual In combination with input function “30: Switch between Motor 1 and Motor 2”, F00.28 can be used to select present motor (see Table 7-3 for details). Table 7-3 Motor Parameter Group Selection F00.29 is used to set a new password to enable password protection function and avoid misoperation of function codes of inverter. If the new password is 0, then the password protection function is disabled. After setting the user password (none 0), in addition to the function code, all the parameters can only be viewed, cannot be modified. 7.2 F01 Group: Motor 1 Parameter EM600 supports the induction motor and synchronous motor.

Please set this parameter according to actual applications. 132 F00.28: Motor Parameter 30: Switch between Motor 1 Enabled Motor Parameter Groups Group and Motor 2 0: Motor 1 Parameter Disabled Motor 1 F00/F01/F06 Enabled Motor 2 Motor 2 F14 1: Motor 2 Parameter Disabled Enabled Motor 1 F00/F01/F06 Name of Function Code Parameter Description Unit Default Property Function Code F00.29 User Password 0 - 65535 0 〇 Function Name of Function Parameter Description Unit Default Property Code Code F01.00 Motor Type 0: Induction Motor 1: Inverter Induction Motor 2:

Permanent Magnet Synchronous Motor 0 〇 Function Name of Function Parameter Description Unit Default Property Code Code F01.01 Motor Rated Power 0.10 - 650.00 kW Up To Specific Model 〇 F01.02 Motor Rated Voltage 50 - 2000 V Up To Specific Model 〇 F01.03 Motor Rated Current 0.01 - 600.00 (Motor Rated Power ≤ 75kW) 0.1 - 6000.0 (Motor Rated Power >75kW) A Up To Specific Model 〇 F01.04 Motor Rated Frequency 0.01 - 600.00 Hz Up To Specific Model 〇 F01.05 Motor Rated Speed 1 - 60000 rpm Up To Specific Model 〇 F01.06 Motor Winding Connection 0: Y 1: Δ Up To Specific Model 〇 F01.07 Motor Rated Power 0.600 - 1.000 Up To Specific 〇