EM600 High-Performance Vector Control Inverter User Manual EM600 inverter supports high-speed pulse output (HDO) function, which is similar to analog quantity output function. Output quantity of inverter is in pulse of different frequency sizes other than voltage values. When inverter is in jog running, user does not need DO to output some status, so setting this function code as 1 to shield corresponding output. If F03.08=xxx1x when FAR is in active output status, then actually selected output terminal does not output active level. This function code is of bit operation type. For specific settings, please refer to table 7-5 of F02.15.
Function i Output Active Inactive 功能 i 输出 有效 无效 Level Output Active Inactive 电平输出 有效 无效 Ineffective Delay Time 无效延时 Monopulse Output Active Inactive 单脉冲输出 Pulse Output Width 有效 无效 Figure 7-16 Numeric Output Terminal Level and Monopulse Output The terminal will delay to response according to function code setting, when function terminal changes. At present, terminals Y1/Y2 and R1/R2 support this function. Specific actions:
corresponding output terminal outputs active level only when function terminal changes from disabled status to enabled status and the effective delay time is reached; corresponding output terminal outputs inactive level only when function terminal changes from enabled status to disabled status and the ineffective delay time is reached. ★ : If function code is set as 0.000s, the delay is disabled accordingly. 脉冲输出宽度 155 Function Code Name of Function Code Parameter Description Unit Default Property F03.07 Y2 Output Type 0: Common Numeric Output 1:
High-Frequency Pulse Output 0 〇 Function Name of Function Parameter Description Unit Default Property Code Code F03.08 Output Status Control at JOG D7 D6 D5 D4 D3 D2 D1 D0 00000 〇 * * * REV FDT2 FDT1 FAR RUN 0: Enabled at JOG 1:
Disabled at JOG Function Code Name of Function Code Parameter Description Unit Default Property F03.09 Y1 Effective Delay Time 0.000 - 30.000 s 0.000 ● F03.10 Y1 Ineffective Delay Time 0.000 - 30.000 s 0.000 ● F03.11 Y2 Effective Delay Time 0.000 - 30.000 s 0.000 ● F03.12 Y2 Ineffective Delay Time 0.000 - 30.000 s 0.000 ● F03.13 R1 Effective Delay Time 0.000 - 30.000 s 0.000 ● F03.14 R1 Ineffective Delay Time 0.000 - 30.000 s 0.000 ● F03.15 R2 Effective Delay Time 0.000 - 30.000 s 0.000 ● F03.16 R2 Ineffective Delay Time 0.000 - 30.000 s 0.000 ● Effecti有ve效 D延ela时y Time