EM600 High-Performance Vector Control Inverter User Manual F04.14=0: Linear Acceleration/Deceleration Output frequency increases or decreases in a straight line progressively and default acceleration/deceleration time is set through function codes F00.14 and F00.15. F04.14=1: S curve acceleration/deceleration During acceleration in Figure 7–17: t1 is the value set through F04.15 and t2 is the value set through F04.16; during deceleration: t3 is the value set through F04.17 and t4 is the value set through F04.18. During the time period of t1 and t2, and t3 and t4, gradient for output frequency changes is fixed.
Output Frequency 输出频率 Linear Acceleration/ Deceleration 直线 加减速 S Curve Acceleration/ Deceleration S 曲线加减 速 Figure 7-17 Acceleration/Deceleration Time Control F04.19=0: Ramp-To-Stop Motor ramps to stop after set deceleration time is out [default setting is as per F00.15 (deceleration time 1)] F04.19=1: Coast-to-Stop After enabling stop command, inverter will stop output immediately and motor will coast to stop. Specific stop time depends upon the inertia of motor and load. If the coast-to-stop terminal is set, inverter coasts to stop immediately after the coast-to-stop terminal is enabled; inverter will not run again even if terminal is disabled unless a run command is inputted. F04.19=1:
Spindle Orientation Enable When Terminal for Running is Disabled Terminal is enabled for starting and stopping, in spindle orientation mode(F30.00=3) if the Terminal is changed from valid to invalid procedure similar to spindle orientation enabled Terminal effective into the spindle orientation features. Stop need keyboard "STOP" key or "free parking" terminals or "external stop Terminal" 160 Function Name of Function Code Parameter Description Unit Default Property Code (F15.13=2) t1 t2 t3 t4 t4 Accel加era速tio时n 间Time Dec减ele速rat时io间n Time Function Name of Function Parameter Description Unit Default Property Code Code F04.19 Stop Mode 0: Ramp-To-Stop 1: Coast-to-Stop 2:
Spindle Orientation Enable When Terminal for Running is Disabled 0 〇