sinee — 7.9 F08 Group: Preset Speed and Simple PLC Parameter

EM600 High-Performance Vector Control Inverter User Manual Output Frequency (Hz) 5 2 1 t (s) 4 12 13 T1 T2 T4 T5 T12 T13 Figure 7-26 Simple PLC Running As illustrated in Figure 7-26, it is running mode after setting “0: Stop after Single Running”. Since preset speed 3 is set as 0 (F08.24=0.0), inverter will not run at preset speed 3 actually. Since preset speed 14 and preset speed 15 are set as 0 (F08.46=0.0 and F08.48=0.0), preset speed 13 is last one and inverter will stop after running at preset speed 13. PLC stop memory function enables inverter to record running times (F18.10), running stage (F18.11) and present running time (F18.12) of present simple PLC at stop.

Inverter continues with the memorized stage for the running of next time. If simple PLC memory function is disabled, PLC process will be started for every time after inverter restart. PLC power failure memory function enables inverter to record running times (F18.10), running stage (F18.11) and present running time (F18.12) of present simple PLC before the power failure. Inverter continues with memorized stage at next energization. If PLC power failure memory function is disabled, PLC process will be started for every time after inverter restart. To meet different applications, setting for running time of PLC can be in figures only.

Specific meanings shall be set together with simple PLC time unit (F08.18). There are two time units available. 181 Function Name of Function Parameter Description Unit Default Property Code Code F08.17 Simple PLC Memory Ones Place: Stop Memory 0: Disabled (Start from the Preset Speed 1) 1: Enabled (Start at Power Failure) Tens Place: Power Failure Memory 0: Disabled (Start from the Preset Speed 1) 1: Enabled (Start at Power Failure) 00 ● Function Code Name of Function Code Parameter Description Unit Default Property F08.18 Simple PLC Time Unit 0: s 1: min 0 ● Function Name of Function Code Parameter Description Unit Default Property Code