EM600 High-Performance Vector Control Inverter User Manual 2 1 3 4 5 6 7 8 9 10 11 Pulse Input Count 2 1 3 4 5 6 7 8 8 8 0 0 Enabled Clear Disabled Designated Output Disabled Figure 7-43 Count (Example) Figure 7-43 shows an example, in which F16.03=8 and F16.04=5. When count reaches 5, “15: Designated Count Value Reach” is enabled; when count reaches 8, “14: Set Count Value Reach” is enabled; when “36: Counter Clear” is enabled, count will be cleared and both “15: Designated Count Value Reach” and “14: Set Count Value Reach” are disabled.
Set Output Disabled Enabled Disabled Set 65535≥Set Count Value≥Designated Count Value≥0; if set count value = designated count value=0, then the counter is disabled; only one terminal can be set with this funct ion for the same time. This function code shall not be set as 0 to start timed run function. When running time reaches set value, inverter stops and output terminal of the function “26: Set Time Reach” is enabled, with a prompt for the reach to running time. User can view remaining time through F18.35 or clear preset running time by input function “27: Clear Timed Run Time” (i.e., reset F18.35).
When inverter is not running, this time indicates set time; when inverter is running, this time refers to remaining time. That is to say, timed run procedure starts from inverter running. After inverter stops, accumulated time is cleared. Agent Password ★: By setting this password, inverter can not be used normally. Please pay enough attention. These codes are used to set accumulated power-on reach time. When accumulated power-on time (F12.15) is equal to or greater than accumulated power-on reach time (F16.07), inverter can not be used.
223 Function Name of Function Code Parameter Description Unit Default Property Code F16.05 Set Timed Run Time 0.0 - 6500.0 Disabled at 0.0 min 0.0 ● Function Code Name of Function Code Parameter Description Unit Default Property F16.06 Agent Password 0 - 65535 0 〇 Function Name of Function Code Parameter Description Unit Default Property Code F16.07 Set Accumulated Power-On Time Reach 0 - 65535, 0: Power-on Reach Time Protection Disabled h 0 〇