EM600 High-Performance Vector Control Inverter User Manual 54 Step Description correct electrical parameters of controlled motor. If motor load can not be removed, select motor stationary autotuning (F01.34=1/11); afterwards, press ENTER of keypad first and then press RUN . If motor is still running, Do not conduct motor parameter autotuning operation. Correctly set rotational direction, forward/reverse control, acceleration/deceleration time, driving mode, start/stop mode, speed torque control mode and other parameters according to applications of driving system.
General Parameter Operation Control Parameter Setting Set function parameters including V/F curve, stator voltage drop compensation and slip compensation, according to load demands. V/F Control Vector Control Set regulator parameters according to load. When motor is idling, start inverter at a low speed and check and confirm running status of driving system: Motor: Motor runs stably and rotates normally and correctly; acceleration/deceleration process is normal, free of abnormal vibration, noise and foreign odor. Inverter: Operation panel displays data normally, fan rotates normally and relay acts normally, free from vibration and foreign odor.
In case of abnormal condition, immediately stop it and cut the power for checking. Idling Trial Operation Check If inverter has passed no-load operation check satisfactorily, conduct on-load trial operation check. Please correctly connect to braking unit and braking resistor. Check whether inverter runs normally and whether braking acts normally by switching forward and reverse. Observe whether inverter outputs corresponding frequency through master controller’s sending of speed signal. Independent braking unit: please observe whether braking unit work light flickers.
On-Load Trial Operation Check In case of any fault, please check whether input and start/stop function codes are correctly set. Basic Operation Normal S Curve Often used for occasions of high-inertia drive system and occasions sensitive to acceleration to reduce mechanic shock and avoid system vibration. Operation Performance Acceleration/ Setting Deceleration