User Manual of EM730/EM730E Series Inverter For general communication (F10.05=0): a 、 F13.08=6: the upper frequency limit is “700BH (communication percentage setting of the upper frequency limit of torque control) * F13.09 (upper frequency limit of torque control)”; b 、 F13.08=7: the upper frequency limit is “7018H (communication setting of the upper frequency limit of torque control)”. (maximum frequency), as detailed in Table 12-31. The 700BH data range is 0.00% to 200.00%, and the 7018H data range is 0.00 to F00.16 The upper frequency limit of torque control is used to set the maximum forward or reverse running frequency of the inverter in the torque control mode.
In the torque control mode, if the load torque is less than the output torque of the motor, the motor speed will rise continuously, and the maximum speed of the motor must be limited during torque control to prevent the mechanical system from galloping and other accidents; if the load exceeds the output torque of the motor and even the motor is drive to run reversely, the maximum operating load frequency of the motor is still restricted in the case of F13.19=1 and not restricted in the case of F13.19=0. The upper frequency limit of reverse running is dependent on F13.09 * F13.18. Example:
The torque is set to be positive and the upper frequency limit of torque control is the AI1 analog input. When the AI1 analog input is positive, the upper frequency limit corresponding to the forward speed limit is AI1 (percentage) * F13.09 and that corresponding to the reverse speed limit is AI1 (percentage) * F13.09 * F13.18; and when the AI1 analog input is negative, the upper frequency limit corresponding to the forward speed limit is AI1 (percentage) * F13.09 * F13.18 and that corresponding to the reverse speed limit is AI1 (percentage) * F13.09.
+ offset of upper frequency limit (valid only when F13.08=1 to 5), but the maximum operating Maximum operating frequency in torque control = upper frequency limit of torque control frequency is limited by the maximum frequency of F00.16. 249 Function Parameter Default Function code name Unit Attribute code description setting F13.11 Static friction torque 0.0-100.0 % 0.0 ●