User Manual of EM730/EM730E Series Inverter Pulse information Count clear signal Fig. 7-42 Block Diagram of Counting Function pulses is collected by the DI terminal and then is compared with the “specified count” 1 n . If Counting principle: Specific information is entered in the pulse form. The number n of 1 n n , it means that the value does not reach the “specified count”. Otherwise, it means that the value reaches the “specified count”, the result is outputted by the DO terminal, counting is continued, and the value is compared with the “set count” 2 n . If 2 n n , it means that the value does not reach the “set count”.
Otherwise, it means that the value reaches the “set count”, the result will be outputted by the DO terminal and counting will be stopped. The “36: clear counter” input can be used to clear the count and reset the output signal. When the pulse frequency exceeds 250Hz (=1/(2 (default filtering times)*2*1ms -1 )), make sure of the input through the high-speed pulse input terminal (X5), and set F02.06 to “35: high-speed count input”. 250Hz is only a theoretical value. The actual effect will prevail. In order to avoid errors, use the high-speed pulse input terminal wherever possible.
2 1 3 4 5 6 7 8 9 10 11 Pulse input Count value 2 1 3 4 5 6 7 8 8 8 0 Clear input Valid Specified output Invalid Invalid Set output Invalid Valid Invalid When the count reaches the specified value 5, the output of “15: reach the specified value” will Fig. 7-16 Counting ExampleFig. 7-16 shows an example, where F16.03=8 and F16.04=5.
269 F18.33 DO “specified count reached” output 15# function DI “count input” 34# function HDI “high-speed count input” Puls Ce nc to Inunt n ≥ ≥ DO “set c 1o 4u #n ft u r ne ca tc ih oe nd” output 35# function Clear to 0 Comparator 1 Comparator 2 Reset Specified count Set count value 0≤ value n1 ≤ n2 1~65535 1~65535 DI “counter reset” input 36# function “Specified count reached” signal DO “set count reached” 14# function output Specified count value n1 1~65535 Set count value ≤ n2 1~65535