sinee — EM760 User Manual

User’s Guide for EM760 series high-performance vector inverter Chapter 9 Function Code Table Description of Function Code Table in the following table, and each group consists of several function codes. Among them, the F18 group is a The EM760 inverters have 22 groups of function codes (hereinafter referred to as “function codes”) as shown monitoring parameter group used to view the inverter status; the F19 group is a fault record group used to view the details of the last three faults; and other groups are parameter setting groups to meet different functional requirements. ★ : Some parameters of the current series are reserved, and their readings are 0.

Some options of parameters are reserved and settable, but this may result in abnormal operation of the inverter. Please avoid misuse of such parameters. ★ Parameter properties: ●: Parameters that can be changed in any state;  : Parameters that cannot be changed in the operating state; Ч: Read-only parameters.

Table of functional parameters 51 F00 Basic function parameter group F01 Parameter group of motor 1 F02 Input terminal function group F03 Output terminal function group F04 Start/stop control parameter group F05 V/F control parameter group F06 Vector control parameter group F07 Protection function setting group F08 Multi-segment speed and simple PLC F09 PID function group F10 Communication function group F11 User-selected parameter group F12 Keyboard and display function group F13 Torque control parameter group F14 Parameter group of motor 2 F15 Auxiliary function group F16 Customization function group F17 Virtual I/O function group F18 Monitoring parameter group F19 Fault record group F21 Special functional parameter groups of the winding machine F45 Modbus free mapping parameter group Functio Default Attri bute Function code name Parameter description Unit n code setting F00 Basic function parameter group F00.01 Drive control mode of motor 1 0:

V/F control (VVF) 1: Speed sensorless vector control (SVC) 2: Speed sensor vector control (FVC) 0  F00.02 Options of command source 0: keyboard control (LOC/REM indicator ON) 1: terminal control (LOC/REM indicator: OFF) 2: communication control (LOC/REM indicator: flicker) 0  F00.03 Options of terminal control mode 0: terminal RUN (running) and F/R (forward/reverse) 1: terminal RUN (forward) and F/R (reverse) 2: terminal RUN (forward), Xi (stop) and F/R (reverse) 3: terminal RUN (running), Xi (stop) and F/R (forward/reverse) 0 