Epson L-6034VW Operation Guide Touch Panel Basic Operations 111 Item Explanation Eye Mark Pitch Set the eye mark gap. Set the Eye Mark Pitch within a range of 30.0 to 1,000.0 mm (1.181 to 39.370 inch). You can switch the units between inch and mm. Disabled when Additional Printing is set to Do Not Apply. Default: 30.0 mm (1.181 inch) See the following when using single-ply film. U “Eye mark pitch (interval) when printing on single-ply films” on page 236 Eye Mark Sensor Position Sets the eye mark sensor position. U “Eye mark detection and sensor sensitivity settings during additional printing” on page 55 Top (default) Select when eye marks are printed on the surface of the substrate.
Bottom Select when eye marks are printed on the rear of the sub- strate. Uneven Color Adjustment Set when applying the uneven color adjustment value. Do Not Apply Does not apply the uneven color adjustment value. Standard Adjustment Value (default) Uses the predetermined adjustment value. This should normally be selected. Additional UV Lamp Curing Set to cure ink using the additional UV lamp curing unit. Do Not Apply The additional UV lamp curing unit is not used. Apply The additional UV lamp curing unit is used to cure ink. If you are using film substrate, perform a test print to check that the substrate has not been damaged by the high temperature, and then select Apply.